Omron V600-CD1D-V2 Operation Manual page 14

Names and Functions of Parts
Power Supply and External Output Terminals
External Output Terminals
R/W Head Connector
RS-232C Interface
Connector
Name
24VDC/0V Supplies 24 VDC
Protective conductor terminal. Connect a ground line grounded at
GR
less than 100 Ω.
RESET External reset input for emergency stop.
TRIG Trigger input informing the Controller of the processing start time
of the DC. The conditions under which this input signal is to be
issued can be set by the DIP switch.
IN1 User input 1 that can be manipulated by a command.
IN2 User input 2 that can be manipulated by a command.
COM Common input terminal.
Name
RUN Turns ON when the ID Controller operates normally and can
communicate with the host controller. This signal is turned OFF in
the test mode.
CMPL Turns ON when communications with the DC have been
completed, and turns OFF when transmission of a response has
started.
OUT1 User output 1 that can be manipulated by a command.
OUT2 User output 2 that can be manipulated by a command.
Connects the R/W Head (R/W Antenna).
Connector for communications with the host computer. Conforming to
RS-232C, this connector can be connected to a general-purpose factory com-
puter or personal computer.
Section
Function
Function
2-1
9