Cisco DX70 and DX80
Introduction
Audio settings
Audio DefaultVolume
Define the default volume for the speakers. The volume is set to this value when you switch
on or restart the video system. Use the controls on the video system to change the volume
while it is running. You may also use API commands (xCommand Audio Volume) to change
the volume while the video system is running, and to reset to default value.
Requires user role: ADMIN, USER
Default value: 50
Value space: Integer (0..100)
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.
Audio Microphones Mute Enabled
Define the microphone mute behaviour on the video system.
Requires user role: ADMIN
Default value: True
Value space: True/InCallOnly
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is
not possible to mute the microphone. This is useful when an external telephone service/
audio system is connected via the codec and is to be available when the codec is not
in a call. When set to InCallOnly this will prevent the audio-system from being muted by
mistake.
D15362.02 DX70 and DX80 Administrator Guide CE8.3, JANUARY 2017.
Configuration
Peripherals
Maintenance
Audio SoundsAndAlerts RingTone
Define which ringtone to use for incoming calls.
Requires user role: ADMIN, USER
Default value: Sunrise
Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.
Audio SoundsAndAlerts RingVolume
Define the ring volume for incoming calls.
Requires user role: ADMIN, USER
Default value: 50
Value space: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
62
Administrator Guide
System settings
System settings
Appendices