Power On And Off - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction Introduction

Power On and Off

Power On/Off with the Power switch or Shutdown button
The power switch on the codec's rear side is its main
On/Off switch.
It may take a few minutes for the codec to start up.
The system is ready for use when the Power LED lights
steadily.
Shutdown You can use the Shutdown button on the front panel
button to switch the codec On/Off, provided that the Power
switch on the codec's rear side is On.
• To switch Off the codec, hold the button until the
LEDs go out.
• To switch On the codec, hold the button until the
LEDs flash. It may take a few minutes for the codec
to start up. The system is ready for use when the
Power LED lights steadily.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Maintenance
Power Off or restart the system remotely
Sign in to the web interface and navigate to
Restart.
Restart the system
Click
Power
Power Off the system
switch
Click
choice.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
13
Administrator Guide
System settings Appendices
Maintenance >
Restart TelePresence device... and confirm your choice.
It will take a few minutes before the system is ready
for use.
Shutdown TelePresence device... and confirm your
The system cannot be powered On again remotely.