Cisco TelePresence SX80 Administrator's Manual page 44

Cisco TelePresence SX80

Introduction
Connect input sources
About video and content quality
Use the Video > Input > Connector n > Quality
quality with respect to motion or sharpness.
Typically, you should choose Motion when a large number of
participants are present or when there is a lot of motion in the
picture. Choose Sharpness when you want the highest quality of
detailed images and graphics.
The default value is Motion for Connector 1, 2 and 5; and
Sharpness for Connector 3 and 4.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 2 of 2)
Set type and name for the input sources
setting to optimize We recommend that you set type and name for the input sources:
• Video > Input > Connector n > InputSourceType
• Video > Input > Connector n > Name
These settings determine the names and icons that are shown
on the user interfaces. Intuitive names and icons make source
selection easier.
Maintenance
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
44
Administrator Guide
System settings Appendices