Connecting Cables - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction
Briefing room set-up

Connecting cables

It is very important to connect the cameras and monitors to the codec as
illustrated; otherwise the configuration that is pushed to the codec when
selecting the Briefing room type template will not match your actual set-up.
Network Microphones,
(LAN) max 8
Audience camera
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 2 of 3)
Loudspeakers,
Computer mono or stereo
1
Presenter camera
Touch 10
2
Maintenance
Remote audience
display
Presentation display
Remote presenter display
50
System settings
Remote
Presentation presenter
display display
If the Audience camera unit is a single camera, you
1
should use camera input 1 for the Audience camera and
Power
camera input 3 for the Presenter camera.
2 If the Ethernet switch does not provide Power over
Ethernet (PoE), you need a mid-span PoE injector
for Touch 10. Refer to the
controller chapter for more information.
3 The Ethernet switch may be connected to either
Network port 2 as illustrated, or to Network port 3.
It cannot be connected to Network port 1, which is
reserved for the LAN connection.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
Audience camera
Remote audience display
Presenter camera
Microphones
► Connect the Touch 10