Cisco TelePresence SX80 Administrator's Manual page 51

Cisco TelePresence SX80

Introduction
Briefing room set-up
Configure the codec
1. Sign in to the web interface, and navigate to
Configuration > Room Types.
2. Click the Briefing thumbnail to push the corresponding
configuration to the codec.
Note that the cameras and displays must be
►Connecting cables
connected as described in the
chapter.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 3 of 3)
Change room mode while in a conference
These are the pre-defined modes for the Briefing room:
• Local Presenter (the presenter is in the room)
• Remote Presenter (the presenter is calling in)
• Discussions (for discussions between different sites
with local presenter in the room)
Switching from one mode to another implies changing the
camera input sources and changing the remote and local
screen layouts.
Switch to another room mode manually
While in a conference, you can switch to another mode
using the Touch controller.
1. Tap Layout
2. Tap the thumbnail that represents the mode you want
to change to.
Maintenance
on the Touch controller.
Room mode thumbnails
51
Administrator Guide
System settings
Switch room modes automatically
The following situations cause an automatic mode
change:
• When you start to share a presentation locally,
the system will automatically change to the Local
Presenter mode.
• When the far end starts to share a presentation,
the system will automatically change to the Remote
Presenter mode.
Note the following exception: The room mode will not
change automatically if the current mode is Discussions.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices