Network [1] Ieee8021X Eap Peap; Network [1] Ipstack; Network [1] Ipv4 Address; Network [1] Ipv4 Assignment - Cisco TelePresence SX80 Administrator's Manual

Hide thumbs Also See for TelePresence SX80:
Table of Contents

Advertisement

Cisco TelePresence SX80
Introduction

Network [1] IEEE8021X Eap Peap

Define the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN
clients without the need for client certificates. Developed by Microsoft, Cisco and RSA
Security.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The EAP-PEAP protocol is disabled.
On: The EAP-PEAP protocol is enabled (default).

Network [1] IPStack

Select if the system should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE:
After changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role: ADMIN
Default value: Dual
Value space: Dual/IPv4/IPv6
Dual: When set to Dual, the network interface can operate on both IP versions at the
same time, and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the system will use IPv4 on the network interface.
IPv6: When set to IPv6, the system will use IPv6 on the network interface.

Network [1] IPv4 Assignment

Define how the system will obtain its IPv4 address, subnet mask and gateway address. This
setting only applies to systems on IPv4 networks.
Requires user role: ADMIN
Default value: DHCP
Value space: Static/DHCP
Static: The addresses must be configured manually using the Network IPv4 Address,
Network IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration
Peripherals
Maintenance

Network [1] IPv4 Address

Define the static IPv4 network address for the system. Applicable only when Network IPv4
Assignment is set to Static.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 64)
A valid IPv4 address.

Network [1] IPv4 Gateway

Define the IPv4 network gateway address. Applicable only when the Network IPv4
Assignment is set to Static.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 64)
A valid IPv4 address.

Network [1] IPv4 SubnetMask

Define the IPv4 network subnet mask. Applicable only when the Network IPv4 Assignment
is set to Static.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 64)
A valid IPv4 address.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
101
Administrator Guide
System settings
System settings
Appendices

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents