Cisco TelePresence SX80 Administrator's Manual page 48

Cisco TelePresence SX80

Introduction
Set up the Snap to Whiteboard feature
Switch the Snap to Whiteboard feature on or off
1. Tap the contact information in the upper left corner of the Touch
controller and open the Settings menu.
2. Tap Administrator, and sign in with administrator credentials.
3. Tap Tracking.
4. When Snap to Whiteboard is set to ON the camera will capture
both the person and the whiteboard when the person that talks is
close to the whiteboard.
Choose OFF if you want only the person to be captured.
Alternatively, use the Cameras > SpeakerTrack > Whiteboard > Mode
setting on the web interface to switch the Snap to Whiteboard feature
On or Off.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 3 of 3)
Maintenance
Since Snap to Whiteboard is an extension to speaker
tracking, tracking must be swithched on when using
Snap to Whiteboard.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
48
Administrator Guide
System settings Appendices