Set Up Speaker Tracking - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Set up speaker tracking

Sign in to the web interface and navigate to
System Configuration, to find the settings referred.
Use the Cameras > SpeakerTrack > Mode
disable speaker tracking.
Off: Speaker tracking is switched off permanently.
Auto: Speaker tracking is enabled in general. Users can
switch it on or off instantly with the camera control panel on
the Touch controller.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
Configuration > Tracking mode
The tracking mode defines how fast the camera view switch to a
new speaker when the tracking algorithm detects a change.
setting to enable or
Use the
select between the two modes.
Auto: This is the default setting.
Conservative: The system reacts slower to detected changes,
and the camera view will switch to a new speaker later.
You can also use the Administrator Settings menu on the
Touch controller to switch between the two tracking modes.
• Tap
• Tap Tracking, and set
NORMAL (conservative).
Maintenance
Cameras > SpeakerTrack > TrackingMode
Settings > Administrator and sign in.
Tracking Mode to FAST (auto) or
45
System settings
About speaker tracking
The following Cisco TelePresence
products support speaker tracking:
setting to
• MX700 and MX800 with dual camera
• SpeakerTrack 60 camera
The two cameras in the assembly work
together with a built-in microphone array
to automatically track and show the
person that speaks.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices