Mount The Speaker Grille - Cisco Room Kit EQX Installation Manual

19. Mount the speaker grille

Both the speaker grille (assembled in this step) and bottom
grille (assembled in step 20) consist of several parts. The
corners and stiffeners are equal for both grilles; the top/
bottom panels are different.
There are marks on the parts, identifying which goes on the
left side and which goes on the right side. Left and right,
referring to the grille laying like shown in the illustrations.
Speaker grille (Box: D)
1x textile speaker grille
1x left corner 1x right corner
1x left stiffener 1x right stiffener
2x top panel (left and right) 1x top panel (center)
34x 1x deco ring
(M4x10, Torx T20)
34x 4x
(M6x8, Hex 4 mm)
(Plastic washer)
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
19.1. Assemble the speaker grille
1. Place the textile speaker grille on a flat and clean surface,
front side down.
×2
49
2. The pegs on the grille has threaded holes for screws.
The left and right corners are fastened to the rear of the
grille with three screws
for each corner.
(Plastic washer)
a. Place the corner onto the pegs as shown in the
illustration.
b. Place the washers on the pegs.
c. Screw through the washers and into the pegs.
6x
6x
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
and washers
(M4x10, Torx T20)