Установка Вакуумного Крепления - Gazer F122G User Manual

Vacuum mount installation
Установка вакуумного крепления
1
Vacuum mount installation
1
Fix the frame and the mount of
Соедините корпус
the device on the windshield.
видеорегистратора с
креплением на лобовое
стекло.
3
Fix the frame and the mount of
1
the device on the windshield.
Loosen the screw 1 by turning it
3
counterclockwise. Adjust the MVR
position on the frame and set the
1
recording angle. Tighten screw 1 by
turning it clockwise.
Recommendation:
Loosen the screw 1 by turning it frame right next to the rear view mirror or behind it) in the
Ослабьте контргайку 1,
counterclockwise. Adjust the MVR
position in which the lens is directed slightly downward at an
position on the frame and set the
angle of about 15°. If the MVR is set too low (on the dashboard
повернув ее против
recording angle. Tighten screw 1 by
or a bit higher), the recorded videos will not provide full
часовой стрелки. turning it clockwise.
information about the road situation as it is impossible to see the
Отрегулируйте положение
front of your vehicle. Therefore, there is no «reference point».
регистратора на креплении
Recordings will be significantly dimmed if the device is set in
Recommendation:
parallel with the road or at an upward angle.
и задайте направление
frame right next to the rear view mirror or behind it) in the
съемки. Зажмите
position in which the lens is directed slightly downward at an
контргайку 1, повернув ее
angle of about 15°. If the MVR is set too low (on the dashboard
or a bit higher), the recorded videos will not provide full
по часовой стрелке.
information about the road situation as it is impossible to see the
front of your vehicle. Therefore, there is no «reference point».
Recordings will be significantly dimmed if the device is set in
parallel with the road or at an upward angle.
Install the MVR and fix the power
Установите видео регистратор
supply cable using mounting clips as
shown in the drawing. Place the clips
и проложите кабель питания
evenly on the windshield to fix the
примерно так, как показано
cable.
на рисунке, используя
набор монтажных клипс.
Распределите клипсы на
Install the MVR and fix the power
лобовом стекле равномерно
supply cable using mounting clips as
shown in the drawing. Place the clips
для закрепления провода
evenly on the windshield to fix the
питания.
cable.
2
To detach the MVR from the mount,
press tab 1. Then, holding the tab,
remove the recorder from the mount by
sliding it to the side 2.
2
Install your MVR as high as possible (MVR
To detach the MVR from the mount,
Для снятия press tab 1. Then, holding the tab,
remove the recorder from the mount by
видеорегистратора с
sliding it to the side 2.
крепления сначала
надавите на язычок 1.
Затем, удерживая язычок,
Install your MVR as high as possible (MVR
отсоедините регистратор с
крепления, сдвинув его в
сторону 2.
2
RU
2
4
1
4
1
37