Table of Contents
Advertisement
Application Macros
Application Macros are preprogrammed parameter sets. They minimise the
number of different parameters to be set during start-up. The Factory Macro
is the factory-set default macro.
Note! The Factory Macro is intended for applications where there is no
control panel available. If using the Factory Macro with control panel note that
the parameters whose value depend on the digital input DI4 cannot be
modified from the panel.
Parameter Values
Selecting an application macro with parameter 9902
other parameters (except the parameter lock 1602 and group 52 serial
communication parameters) to their default values.
Default values of certain parameters depend on the selected macro. These
are listed with the description of each macro. Default values for other
parameters are given in "ACS 140 Complete Parameter List" starting on page
23.
Connection Examples
In the following connection examples please note:
•
All the digital inputs are connected using negative logic.
•
The signal type of analogue input is selected with U/I jumper S1.
Frequency reference
is given with
voltage signal (0 - 10 V)
current signal (0 - 20 mA)
APPLIC MACRO
U/I Jumper S1:1 or S1:2
open
connected
will set all
13
Advertisement
Table of Contents
