Table of Contents
Advertisement
Control Panel
The control panel can be connected to and detached from the converter at
any time. The panel can be used to copy parameters to other ACS 140.
Control modes
Active Fault
indicator
Display modes
START/STOP
REVERSE
Control Modes
The very first time the drive is powered up, it is controlled from the Control
Terminals (remote control, REM). The ACS 140 is controlled from the control
panel when the drive is in local control (LOC).
Switch to local control (LOC) by pressing and holding the MENU and ENTER
buttons down simultaneously until first Loc or later LCr is displayed:
•
If the buttons are released while Loc is displayed, the panel frequency
reference is set to the current external reference and the drive is stopped.
•
When LCr is displayed, the current run/stop status and the frequency
reference are copied from the user I/O.
Start and stop the drive by pressing the START/STOP button.
Change the shaft direction by pressing the REVERSE button.
Switch back to remote control (REM) by pressing and holding the MENU and
ENTER buttons down simultaneously until rE is displayed.
Shaft Direction
FWD / REV Visible
FWD / REV Blinking rapidly
FWD / REV Blinking slowly
LOC
REM
FAULT
6(7
OUTPUTPAR
MENU FWDREV
UP/DOWN
• Shaft direction is forward / reverse
• Drive is running and at set point
Drive is accelerating / decelerating.
Drive is stopped.
Units
mAVs
kHz
%
o
Crpm
Shaft direction
MENU
H@IV
LOC REM
GP8ÃÃS@H
ENTER
(17(5
3
Advertisement
Table of Contents
