Installing Cellular - Interlogix ZEROWIRE ZW-6404 Installation Manual

Installing Cellular Radio
1. A mobile phone can provide general guidance on mobile network coverage. Look at the
signal level on a mobile phone to verify there are 4/5 to 5/5 bars of reception in the
location where you will install the ZeroWire.
1 bar 2 bars
Low
If the signal strength is low, find another location which has stronger signal levels.
Note that actual signal level can only be determined using the ZeroWire connected to a
specific network, which may be different than your phone.
2. If a cellular radio module is pre-installed, skip to the Check Signal Level section. If not,
remove the cover on the right.
3. Locate the 10-pin lead inside the ZeroWire and connect this to the radio module.
Connecting Power
1. Connect a DC power lead from power pack to the back of the ZeroWire, it only fits
when inserted in the correct direction.
20
3 bars 4 bars 5 bars
OK