Interlogix ZEROWIRE ZW-6404 Installation Manual page 35

In order to check the 3G radio signal strength:
1. Turn on WiFi Discovery Mode – this provides direct access to the ZeroWire from a
mobile device such as a smart phone, tablet, or laptop:
MENU
1.
YOUR 4 TO 8 DIGIT INSTALLER CODE
2.
3.
4. MENU
2. Enable WiFi on your mobile device.
3. On your mobile device, browse for available WiFi networks and select the
'ZeroWire_xxxx" network to connect to it. Only a single user can connect at any time
and there is no WiFi password. Once connected, the ZeroWire will be assigned a fixed
IP address of 192.168.1.3.
4. Open your web browser and enter http://192.168.1.3. The ZeroWire login screen
should appear.
5. Enter your username and password, by default this is "installer" and "9713"
6. Click Sign In, you should now see a screen similar to the one below:
Note: The set of accessible menus depends on the access rights of the user logged in the
system. The screen above shows default installer menus, but they can be different for a
Master User, standard user, and an installer with Master User rights. For more information,
see "Access rights and available menus" on page 37. The same applies to a connection
via the UltraSync + app.
7. Click Settings.
8. Select Connection Status in the drop down menu.
ZeroWire Installation Manual
9
ENTER
8
MENU
Select main menu - Option 9, Advanced system
configuration.
Enter your Installer code.
Turn on WiFi Discovery Mode for 10 minutes.
Exits from Advanced system configuration menu.
35