Wired Lan - Interlogix ZEROWIRE ZW-6404 Installation Manual

Wired LAN Setup
1. Connect power to your ZeroWire.
2. If this ZeroWire was previously connected via WiFi, switch the connection to Wired
LAN:
MENU
1.
YOUR 4 TO 8 DIGIT INSTALLER CODE
2.
3.
4. MENU
3. Connect an Ethernet cable to the rear of the ZeroWire and wait 10 sec for the local
router to assign the ZeroWire an IP address.
4. On the ZeroWire press Menu, 8, [PIN], 6 and note the IP address announced. If you
hear "IP address is not configured" then wait a further 30s and repeat this step.
5. Open your web browser.
6. Enter http://[IP address]. The ZeroWire login screen should appear:
7. Enter your username and password, by default this is "installer" and 9713.
8. You should now see a screen similar to the one below.
32
9
ENTER
7
MENU
Router
Select main menu - Option 9, Advanced system
configuration.
Enter your Installer code.
Toggle between Wireless LAN and Wired LAN
connection modes.
Exits from Advanced system configuration menu.
To internet