Upgrading Firmware Using Usbup - Interlogix ZEROWIRE ZW-6404 Installation Manual

Upgrading Firmware using USBUP

If connecting with DLX900 is not possible, the USBUP upgrade tool provides an alternative
method to perform firmware and voice updates. Please refer to the User Manual that
comes with the USBUP for the most up to date instructions.
1. Check with your supplier to download the latest firmware file for your device.
2. Create a folder on the USBUP called "ZEROWIRE".
3. Copy the firmware files into this folder.
4. Take the ZeroWire off the wall and remove the cellular modem cover on the right.
5. A cellular modem may be pre-installed. Carefully remove it from the cavity but leave it
connected.
6. The 5-pin USBUP header is inside the ZeroWire panel:
7. Connect your USBUP to this header using the cable supplied with your USBUP.
8. Press and hold the button on the USBUP until the light begins to flash green rapidly.
Release the button and USBUP will continue the firmware transfer.
9. When the light stays lit orange the firmware was successful. Disconnect the cable and
replace the USB modem and cover.
10. If the light flashes red slowly then there has been an issue performing the upgrade.
Check the files are correct and in the right folders on the USBUP then try again. You
may also open the log file that is written to the USBUP for more diagnostic information.
102