Password Programming - Sanyo SFX-110 Instruction Manual

If you enter a wrong password or a wrong remote code, 5 short beeps alert you. Then 2
beeps sound and you can re-enter the correct password or remote code.
If you continuously enter 3 wrong password, the line will be disconnected.
If greeting does not stop after you enter [ $f ], press it again for 2-3 seconds.
If you take more than 10 seconds to enter a remote operation code, the line will be
disconnected.
Password programming (only for SFX-210)
To be accessible by a remote operation, a 4-digit password must have been programmed
by you. The default password is "321 O".
1. Press [MENU] 5 times.
5: SET ANSW MODE?
2. Press [SET1.
3. Press [SETl again.
4. Enter your new password.
Example: 4321
5. Press [SET1.
A beep sounds.
II :PASSWORD ? I
PASSWORD ?
321~
lpASSWORD ? 43201
2: RECORD MODE ?
6. Press [STOP] to return to stand-by mode.
26 Jun. 12:00 00
If you enter a wrong password at step 4, re-enter the correct one,
To change the password, restart from the first step,
57