Automatic Transmission - Sanyo SFX-110 Instruction Manual

Automatic transmission
You can send a fax without using the handset or speaker key. This is called "automatic
transmission" since your unit automatically sends a fax signal to the party if you do not use the
handset or speaker key.
1. Place the original document face down.
Adjust the paper guide to the width of the document.
STD NORMAL
2. Select a contrastkesolution mode if
necessary. (See page 30.)
I STD NORMAL I
3. Dial the number.
Example: 123456
123456
You can use one of the following dialing methods:
One-touch dialing
Press a one-touch key (1 - 8). Programming is required in advance. See pages 64-65.
Speed dialing
Press [SPEED DIAL] and enter the speed dial number (01 - 20). Programming is required
in advance. See pages 66-67.
Dial Bank dialing
Press [DIAL BANK] to select a number from the 20 most frequently dialed number list
stored in Dial Bank. Then press [START1. See page 26-27.
Direct dialing
Dial the number using the number keys and press [START1.
4. When the line is connected, transmission begins
automatically.
Al ison McNab
I
The name/number of the receiving party appears
on your display if their fax machine has a station
ID programmed.
If the line is busy or there is no answer, the unit automatically rediais the number 2 times.
(See page 33.)
Press [STOP] to interrupt a transmission or to remove a document set for transmission.
If you make a mistake when dialing a number, press [STOP], then enter the correct number.
32