Machine Initial; Machine Programming - Sanyo SFX-33 Service Manual

(5) Machine initial
L.
1. Connect AC plug into AC outlet.
10ct .26 '95 12:001
-
2. Press [MENU] while [SETl key is being pressed and
keep this condition one second.
l: INITIAL SET ?
3. Press [SET].
IALL CLEAR ? I
4. Press [SET] or [MENU].
!
[SET] : Initialize all memories then goes to next mode
"RAM CODE SET".
S-RAM check is also carried out at the same time.
[MENU] : Initialize individual memory.
In case of pressing [MENU], follow the steps below
5. Press [SET] or [MENU].
[SET] : Initialize RAM CODE DATA and goes to next item
"0.T & S.D DATA".
[MENU] : Not initialize RAM CODE DATA, just goes to next
item "0.T & S.D DATA".
6. Press [SET] or [MENU].
[SET] : Initialize O.T & S.D DATA and goes to next item
"REPORT DATA".
[MENU] : Not initialize O.T & S.D DATA, just goes to next
item "REPORT DATA".
7. Press [SETl or [MENU].
[SETl : Initialize REPORT DATA and goes to next item
"RAM CODE SET".
[MENU] : Not initialize REPORT DATA, just goes to next
item "RAM CODE SET".
2: RAM CODE SET ?
IRAM CODE CLEAR ?I
10. T & S.D CL EAR? I
lREPORT DATA CLR?I
2: RAM CODE SET ?
8. Press [STOP/C] to finish Machine initial setting.
REMARKS
L In case of S-RAM Error at step 4, alarm sounds continuously and the machine
goes into "DEAD LOCK" condition Repair is required. (check S-RAM and its 1/0 signals)
(6) Machine programming
(6)-1 Setting your station name and fax number (Header)
1.Press [MENU] 4 times.
2. Press [SET1.
4: SET MODE ?
l: TIME SET ?
3. Press [MENU].
7