Sanyo SFX-110 Instruction Manual page 90

Symptoms
Possible Cause&Solution Page
~a Error lamp lights,
Press [STOP] to turn off the error light.
E May be a communication error due to a poor -
~g
line connection.
No dial tone when handset is Telephone cord may not be connected
1 '--
picked up. properly.
12
=
co
u
Sound from speaker is Monitor volume switch may be set to lower
a)
too low.
position.
7
c
2
No rings are heard. Ringer volume switch may be set to "OFF'. 7
L
Fax/phone call does not Wrong dialing mode may be set.
connect to other party. Check the feature switch No.00.
13
Q
Impossible to place phone call. Fax possibly being transmitted or received. –
c
Telephone does not ring.
2
Too many phones may have been connected ,2
Q
to the same line.
c
o .-
Remote reception does not Remote reception feature switch (No. 08)
m
c
work.
may have been set to off.
79
a)
z If you have initiated the call from the extension
LIJ
phone, remote reception will not work.
No messages recorded. The memory for answering system is full.
(only for SFX-21O) (You have too many incoming messages.) 54
Erase some or all messages.
L
The message recording mode may be set to
.,
..
ANSWER only. Change it to VOX(3 MIN) or 58
al
FIX 30 SEC.
> Your greeting cannot be
%
The memory for answering system is full.
m
recorded. (You have too many incoming messages.) 54
P (only for SFX-21 O) Erase some or all messages.
.—
G
z
The fax telephone or extension telephone
w
connected to the unit may be in use.
z
Remote access operation You may be using a pulse-dialing phone.
does not work. Call from a Touch-Tone dialing phone
56
(only for SFX-21O) The [ % ] key may not be pressed correctly.
Press it firmly. The 4-digit password may not 56
be entered correctly.