Selective Reception - Sanyo SFX-110 Instruction Manual

Selective reception
This feature allows you to restrict reception to certain parties. Using the feature switch No. 26,
you can select either ACCEPT mode, REFUSE mode or OFF. (The initial factory-set
position is OFF.) See page 80.
Accept
Reception is possible only when the other party's fax number is programmed in the one-
touch or speed dial memory of your SFX-1 10/21 O.
If a fax arrives from other numbers than those programmed in the memory of your unit, the
SFX-1 10/210 will disconnect from the line after the display shows RECEIVING.
If a party's fax machine does not have a station identification feature or the station number
has not been programmed in their fax machine, no faxes will be received from this number
(even if the number is programmed in your unit.)
Refuse
The SFX-1 10/21 O allows you to create a Refuse list and store up to 20 fax numbers in its
memory. The SFX-1 10/21 O will not receive faxes sent from the parties whose numbers are
programmed in the Refuse list.
The Refuse feature checks the last 4 digits of a number.
When the Refuse mode is selected, the SFX-1 10/21 O will not receive faxes from any party
whose unit has no station identification feature or whose station number is not
programmed in their unit.
Programming the Refuse list
1. Press [MENU] 4 times.
SFX-21O: 4: SET FAX MODE ?
SFX-110:14: SET MODE ?
I
2. Press [SET1.
l: SET TIME ?
3. Press [MENU] 4 times.
15: REFusE LIST ? I
4. Press [SET'J.
gB:s ET 2: DELETE
5. Press [SET1.
(01)
I :SET
48