Setting The Chassis On A Desktop - Cisco ASA 5505 Hardware Installation Manual

Chapter 3 ASA 5510, ASA 5520, ASA 5540, and ASA 5550

Setting the Chassis on a Desktop

To set the chassis on a desktop, perform the following steps:
Locate the rubber feet on the black adhesive strip that shipped with the chassis.
Step 1
Figure 3-7
1
Place the chassis upside down, on a smooth, flat surface.
Step 2
Peel off the rubber feet from the black adhesive strip and press them adhesive-side down onto the bottom four
Step 3
corners of the chassis, see
Figure 3-8
1
Place the chassis right-side up on a flat, smooth, secure surface.
Step 4
Connect the interface cables. See the
Step 5
information.
78-17374-01
Identifying the Rubber Feet
1
2
Rubber feet 2 Black adhesive strip
Figure
Attaching the Rubber Feet
1
Rubber feet
3-8.
"Connecting the Interface Cables" section on page 3-8
Cisco ASA 5500 Series Hardware Installation Guide
Installing the Chassis
for more
3-7