Installing An Ssm - Cisco ASA 5505 Hardware Installation Manual

Appendix A Installing and Replacing the SSM
This section describes how to install and replace the SSM in the adaptive security appliance. This section
includes the following sections:
•
•
Figure A-6
Figure A-6
Table A-6
Table A-6
1
2
3
4

Installing an SSM

The following is only supported on the ASA 5510, ASA 5520, and ASA 5540.
Note
To install a new SSM for the first time, perform the following steps:
Step 1 Power off the adaptive security appliance.
Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare
skin. Attach the other end to the chassis.
Step 3 Remove the two screws (as shown in
cover.
78-17374-01
Installing an SSM, page A-9
Replacing an SSM, page A-10
lists the SSM LEDs.
SSM LEDs
describes the SSM LEDs.
SSM LEDs
LED Color State
PWR Green On
STATUS Green Flashing
Solid
LINK/ACT Green Solid
Flashing
SPEED Off 10 MB
Green 100 MB
Amber 1000 MB (GigE)
3 4
1 2
Description
The system has power.
The system is booting.
The system has passed power-up diagnostics.
There is an Ethernet link.
There is Ethernet activity.
There is no network activity.
There is network activity at 100 Mbps.
There is network activity at 1000 Mbps.
Figure A-7) at the left rear end of the chassis, and remove the slot
Cisco ASA 5500 Series Hardware Installation Guide
Installing and Replacing the SSM
A-9