Cisco ASA 5505 Hardware Installation Manual page 67

Appendix B Maintenance and Upgrade Procedures
Lift the rear of the chassis from the surface and unscrew both the screws that secures the power supply to
Step 6
the chassis, as shown in
Figure B-5
1
Locate the power connector on the system board.
Step 7
Step 8 Unlatch the plug, then grasp the sides of the power connector and pull upward while rocking the connector
from side to side. Disconnect the power connector from the system board as shown in
Figure B-6
1
AC power supply
OL-10089-01
Figure B-5.
Removing the Power Supply Screws
FL A S H
1
Chassis bottom
Disconnecting the Power Connector
2
2
Power connector
Removing and Replacing the Power Supply
1
Cisco ASA 5500 Series Hardware Installation Guide
Figure B-6.
B-5