Mount The Chassis; Desktop-Mount The Chassis - Cisco ASA 5506-X Installation Manual

Mount the Chassis

Note Do not remove the rubber feet included with the ASA because they are needed for proper cooling for all
mounting orientations.
•
•
•
•

Desktop-Mount the Chassis

You can mount the chassis on a desktop by placing it on a desk in a horizontal position. Make sure there are
no blockages or obstructions within one inch of the top of the chassis or within .5 inch of the sides and back,
so that nothing interferes with cooling. Do not remove the rubber feet included with the chassis. They are also
needed for proper cooling.
Caution
Do not stack the chassis on top of another chassis. If you stack the units, they will overheat, which causes the
units to power cycle.
Online Only
Desktop-Mount the Chassis, on page 27
Wall-Mount the Chassis, on page 28
Rack-Mount the Chassis, on page 29
Install the ASA 5506H-X in a DIN Rail, on page 30
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
3
C H A P T E R
27