Removing and Replacing the CompactFlash
Replace the DC power supply plastic shied.
Step 11
Power on the adaptive security appliance from the switch at the rear of the chassis.
Step 12
If you need to power cycle the DC adaptive security appliance, wait at least 5 seconds between powering
Note
off the adaptive security appliance and powering it back on.
Removing and Replacing the CompactFlash
The adaptive security appliance has two types of CompactFlash: the system CompactFlash (internal) and
the user CompactFlash (external). This section includes the following topics:
•
•
•
•
Removing the System CompactFlash
To remove the system CompactFlash, perform the following steps:
Power off the adaptive security appliance.
Step 1
Remove the power cord and other cables from the adaptive security appliance.
Step 2
Remove the adaptive security appliance from the rack if it is rack-mounted.
Step 3
Place the adaptive security appliance in an ESD-controlled environment. See the
Step 4
Environment" section on page B-4
Remove the adaptive security appliance cover. See the
Step 5
page B-1
Cisco ASA 5500 Series Hardware Installation Guide
B-10
Removing the System CompactFlash, page B-10
Replacing the System CompactFlash, page B-12
Removing the User CompactFlash, page B-13
Replacing the User CompactFlash, page B-14
for the procedure.
Appendix B
for more information.
"Removing the Chassis Cover" section on
Maintenance and Upgrade Procedures
"Working in an ESD
OL-10089-01