Creating Route Maps; Sample Configuration; Static Routing - Cisco ASR 5000 Administration Manual

Routing

Creating Route Maps

Use the following configuration example to create a Route Map:
config
context context_name
Notes:
• Use the match and set commands in Route Map Configuration mode to configure the route map. Refer
• Save your configuration as described in the Verifying and Saving Your Configuration chapter.

Sample Configuration

The example below shows a configuration that creates two route access lists, applies them to a route map,
and uses that route map for a BGP router neighbor.
The example below shows a configuration that creates two route access lists, applies them to a route map,
and uses that route map for a BGP router neighbor.
config
context isp1

Static Routing

The system supports static network route configuration on a per context basis. Define network routes by
specifying the:
• IP address and mask for the route
• Name of the interface in the current context that the route must use
• Next hop IP address
Important
route-map map_name { deny | permit } seq_number
to the Command Line Interface Reference for more information on these commands.
route-access-list named RACLin1a permit 88.151.1.0/30
route-access-list named RACLin1a permit 88.151.1.4/30
route-access-list named RACLany permit any
route-map RMnet1 deny 100
match ip address route-access-list RACLin 1 a
#exit
route-map RMnet1 deny 200
match ip address route-access-list RACLin 1 b
#exit
route-map RMnet1 permit 1000
match ip address route-access-list RACLany
#exit
router bgp 1
neighbor 152.20.1.99 as-path 101
neighbor 152.20.1.99 route-map RMnet1
On the ASR 5000, static routes with IPv6 prefix lengths less than /12 and between the range of /64 and
/128 are not supported.
ASR 5000 System Administration Guide, StarOS Release 21.1
Creating Route Maps
255