Creating Vlan Tags; Verifying The Port Configuration - Cisco ASR 5000 Administration Manual

VLANs

Creating VLAN Tags

Use the following example to create VLANs on a port and bind them to pre-existing interfaces. For information
on creating interfaces, refer to System Interface and Ports.
config
port ethernet slot
no shutdown
vlan vlan_tag_ID
no shutdown
bind interface interface_name context_name
end
Notes:
• Optional: Configure VLAN-subscriber associations. Refer to
• Repeat this procedure as needed to configure additional VLANs for the port.
• Refer to
• Save your configuration as described in the Verifying and Saving Your Configuration chapter.

Verifying the Port Configuration

Run the following command to verify the port configuration:
[local]
An example of this command's output when at least one VLAN has been configured for the port is shown
below:
Port: 17/1
port
/
on page 284 for more information.
VLAN-Related CLI Commands , on page 285
additional information.
host_name show port info slot
#
Port Type
Role
Description
Controlled By Card
Redundancy Mode
Framing Mode
Redundant With
Physical ifIndex
Administrative State
Configured Duplex
Configured Speed
MAC Address
Boxer Interface TAP
Link State
Link Duplex
Link Speed
Flow Control
Link Aggregation Group
Untagged:
Logical ifIndex
Operational State
Tagged VLAN: VID 10
Logical ifIndex
VLAN Type
VLAN Priority
Administrative State
Operational State
Configuring Subscriber VLAN Associations,
and the Command Line Interface Reference for
port
/
: 1000 Ethernet
: Service Port
: (None Set)
: 1 (Packet Services Card)
: Port Mode
: Unspecified
: 33/1
: 553713664
: Enabled
: Auto
: Auto
: 02-05-47-72-78-00
: None
: Up
: Unknown
: Unknown
: Disabled
: None
: 285278209
: Up, Active
: 285278210
: Subscriber
: 0
: Enabled
: Up, Active
ASR 5000 System Administration Guide, StarOS Release 21.1
Creating VLAN Tags
283