Boot Using A Specified Configuration File - Cisco ASR 5000 Administration Manual

Boot Using A Specified Configuration File

You can exit the Quick Setup Wizard by entering no in response to the above prompt. Load a desired
configuration file using the Exec mode configure command followed by the URL for the configuration file
as shown in the example below:
[local]
Boot Using A Specified Configuration File
This procedure boots the system using the specified boot image and configuration file. A sample command
string appears below:
8/0:cli>boot -config=/flash/system.cfg /flash/image_filename.bin
The boot sequence ends with the appearance of the CLI prompt.
[local]
Confirm that the desired configuration has loaded by running the Exec mode show configuration command.
ASR 5000 System Administration Guide, StarOS Release 21.1
308
host_name
configure /flash/system.cfg
#
host_name
#
System Recovery