Enabling Monitor Logs; Disabling Monitor Logs; Viewing Logging Configuration And Statistics - Cisco ASR 5000 Administration Manual

Enabling Monitor Logs

Enabling Monitor Logs
Use the following example to configure monitor log targets:
configure
logging monitor { ip_addr | ipv6_addr | msid id | username name }
end
Repeat to configure additional monitor log targets.

Disabling Monitor Logs

Use the following example to disable monitor logs:
configure
no logging monitor { ip_addr | ipv6_addr | msid id | username name }
end

Viewing Logging Configuration and Statistics

Logging configuration and statistics can be verified by entering the following command from the Exec mode:
[local]
When no keyword is specified, the global filter configuration is displayed as well as information about any
other type of logging that is enabled.
The following table provides information] and descriptions of the statistics that are displayed when the verbose
keyword is used.
Table 11: Logging Configuration and Statistics Commands
Field
General Logging Statistics
Total events received
Number of applications receiving
events
Logging Source Statistics
Event sequence ids by process
Msg backlog stat with total cnt
LS L2 filter drop rate
Abnormal Log Source Statistics
Runtime Logging Buffer Statistics
ASR 5000 System Administration Guide, StarOS Release 21.1
180
host_name show logging [ active | verbose ]
#
Description
Displays the total number of events generated by the system.
Displays the number of applications receiving the events.
Displays a list of system processes that have generated events and
the reference identification number of the event that was generated.
Displays the number of event messages that have been back logged
in comparison to the total number of events generated.
Displays the percentage of logging source (LS) layer 2 (L2) event
drops.
Displays abnormal logging source (LS) statistics, if any.
System Logs