Procedure Using A Vga Cable - Amcrest NVR11H Quick Start Manual

Hardware Setup
6. Then, take the power plug and connect it to the brick on one end.
7. Finally, connect the other end of the power cable into a wall outlet or power strip. Your
NVR can now be powered on. Press the power button
Note: Your NVR may not work properly if the following is not accounted for.
Every single NVR comes preset to a video output resolution of 1280x1024. What this means is
that any time an HDMI cable is plugged into an HDTV, it may result with a blank screen even if
the NVR is operational.
If this occurs, please follow the steps below.

Procedure using a VGA cable:

1. Connect your NVR to a computer monitor or TV screen with a VGA cable (the HDMI
cable should not be connected during this process).
2. Boot up your NVR. When the interface loads, you will see the login screen appear. On
the monitor or TV, please make sure the "input" is set to VGA.
3. On your NVR, open the Main Menu by left-clicking once on the live feed screen and,
under the Settings row, click on the System icon. Then, on the new window, click Display
from the list on the left column of options. Change your resolution from 1280x1024 to
1920x1080 and click Apply down below. Your NVR will reset to effect the change.
4. Disconnect the VGA cable and connect your NVR to an HD monitor or TV using an HDMI
cable. Don‟t forget to change the input to HDMI on a TV. Your interface will now appear
and you can use your NVR freely.
- PLEASE READ BELOW-
Setting up the cable connections
on the front panel.
12