CyberData 011214 Operation Manual page 73

Web Page Item
Fast Blink
Color
Brightness
Red
Green
Blue
Note
Note
Operations Guide
Table 2-19. Sensor Configuration Parameters (continued)
Description
Strobe will blink ON at the specified brightness then OFF five times per second
during the duration of the event.
Select desired color (only one may be chosen).
How bright the strobe will blink when the intrusion sensor is triggered. This is the
maximum brightness for "fade" type scenes.
The red LED value for the Intrusion Sensor.
The green LED value for the Intrusion Sensor.
The blue LED value for the Intrusion Sensor.
Use this button to preview the strobe flashing behavior for the Intrusion Sensor
Strobe Settings.
Click the Test Door Sensor button to test the door sensor.
Click the Test Intrusion Sensor button to test the Intrusion sensor.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of the web
page items. First click on the Toggle Help button, and you will see a question
mark ( ) appear next to some of the web page items. Move the mouse pointer
to hover over a question mark to see a short description of a specific web page
item.
You must click on the Save button for the changes to take effect.
None of the Sensor Configuration Page
effect.
930809U
Installing the SIP Outdoor Intercom with Keypad
Configure the Sensor Configuration Parameters
settings require a reboot for the changes to take
CyberData Corporation
65