CyberData 011214 Operation Manual page 100

4. Click on the Firmware menu button to open the Firmware page. See
v11.7.1
5. Click on the Browse button, and then navigate to the location of the firmware file.
6. Select the firmware file.
7. Click on the Upload button.
Note
Note
8.
Web Page Item
Current Firmware Version
Operations Guide
Caution
Equipment Hazard: CyberData strongly recommends that you first reboot the
device before attempting to upgrade the firmware of the device. See
"Reboot the
GENERAL ALERT
Figure 2-38. Firmware Page
Do not reboot the device after clicking on the Upload button.
This starts the upgrade process. Once the Intercom has uploaded the file, the Uploading
Firmware countdown page appears, indicating that the firmware is being written to flash.
The Intercom will automatically reboot when the upload is complete. When the countdown
finishes, the Firmware page will refresh. The uploaded firmware filename should be
displayed in the system configuration (indicating successful upload and reboot).
Caution
Equipment Hazard: Restore the factory defaults after upgrading the firmware. See
Section 2.7.2, "Reboot the
GENERAL ALERT
Table 2-25 shows the web page items on the Firmware page.
Installing the SIP Outdoor Intercom with Keypad
Device".
Device".
Table 2-25. Firmware Parameters
Description
Shows the current firmware version.
Use the Browse button to navigate to the location of the
Intercom firmware file that you want to upload.
Click on the Upload button to automatically upload the selected
firmware and reboot the system.
930809U
Downloading the Firmware
Figure 2-38.
Section 2.7.2,
CyberData Corporation
92