CyberData 011214 Operation Manual page 5

Revision Information
Revision 930809U, which corresponds to firmware version 11.7.1, was released on March 17, 2017,
and has the following changes:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Operations Guide
Updates Figure 1-1, "Model Number Label"
Updates Table 1-1, "Specifications"
Adds Section 1.7, "Compliance"
Adds Section 2.4, "Connecting an Auxiliary RGB Strobe to the Intercom"
Adds Section 2.5, "Connecting a SIP RGB Strobe to the Intercom"
Updates Figure 2-20, "Home Page"
Updates Figure 2-21, "Device Configuration Page"
Updates Figure 2-23, "Button Configuration Page"
Updates Figure 2-25, "SIP Configuration Page"
Updates Figure 2-26, "SIP Page Set to Point-to-Point Mode"
Updates Figure 2-27, "Multicast Configuration Page"
Updates Figure 2-28, "Sensor Configuration Page"
Updates Figure 2-30, "Audiofiles Configuration Page (continued)"
Updates Figure 2-34, "Event Configuration Page"
Updates Figure 2-36, "Autoprovisioning Page"
Updates Figure 2-38, "Firmware Page"
Updates Figure 2-39, "Home Page"
Updates Figure 2-35, "DSR Page (not associated with any DSRs)"
Adds the following notes to
• Note: You must click on the Save button and then the Reboot button for the changes to take
effect.
• Note: The SIP Volume, Multicast Volume, Ring Volume, Sensor Volume, and Push to Talk
Volume settings do not require a reboot for the changes to take effect.
• Note: The NTP Server setting needs to be restarted to spawn NTP or to change the server.
Syncing and changing the Time update period (in hours) setting does not require a reboot
for the changes to take effect.
• Note: None of the Relay Settings require a reboot for the changes to take effect.
• Note: The Disable HTTPS (NOT recommended) setting requires a reboot for the changes to
take effect.
Adds the following notes to
• Note: You must click on the Save button for the changes to take effect.
• Note: The Multicast Address and Multicast Port settings require a reboot for the changes to
take effect.
• Send Multicast Audio:
Adds the following notes to
• Note: You must click on the Save button and then the Reboot button for the changes to take
effect.
• Note: The Terminate Call After Delay setting does not require a reboot for the changes to
take effect.
to add IP Rating
Table 2-8, "Device Configuration
Table 2-13, "Button Configuration
Note: The keypad must be in Security mode to send Multicast Audio.
Table 2-17, "SIP Configuration
930809U
and Compliance
Parameters":
Parameters":
Parameters":
CyberData Corporation