Table of Contents
Advertisement
Oven interior
● Do not hand - clean the door seal.
● Do not use coarse scouring pads or cleaning sponges.
● To avoid damaging the enamelled oven surfaces, use commercially available oven cleaners.
● To remove stubborn soil, use a special oven cleaner.
Oven door glass
The oven door is equipped with three sheets of glass placed against each other. The inner & middle
sheets can be removed for cleaning.
WARNING
● Whenever the door is separated from the oven, the clips should be flipped open.
● Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they
can scratch the surface, which may resulting in shattering of the glass.
● When the door is mounted, removing some of the parts (the door glass or some other part) from
the door may result in injury.
Attention
The glass may break if you use excessive force especially at the edges of the front sheet.
Accessories
Wash all bake ware and accessories after each use and dry with a kitchen towel. To clean easily, soak
in warm soapy water for about 30 minutes.
Catalytic enamel surface
The removable cover casing is coated with a dark gray catalytic enamel that can become coated with
oil and fat distributed by circulating air during convection heating. These deposits will burn off at
oven temperatures of 200 °C and higher, for example, when baking or roasting.
Higher temperatures will result in faster burning. The oven and accessories should be cleaned after
each use. Otherwise further baking and roasting will cause the deposits to bake on even harder and
cleaning may become difficult and in extreme cases impossible.
Cleaning by hand
Make sure the oven is cool before cleaning.
● The catalytic enamelled cover casing should be cleaned using a solution of hot water and washing-
up liquid applied with a soft nylon brush.
Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives or
other abrasive materials. Do not use oven spray on catalytic enamel as the chemicals used in oven
sprays will damage catalytic enamel and render it ineffective.
If using oven sprays on the interior oven surfaces, the catalytic cover casing must first be removed
from the oven.
Cleaning with high temperatures
Before cleaning the catalytic cover casing with high temperatures, make sure that all interior oven
surfaces have been cleaned as described above. Otherwise, the high temperatures can bake deposits
onto the interior oven surfaces and make them impossible to remove.
If, after manual cleaning, the oven is still heavily soiled, heating it to a high temperature will help
remove soiling caused by oil and grease splashes.
Note that deposits of spices, syrups and similar substances are not removed by this process. These
should be removed by hand with a mild solution of hot water and washing-up liquid applied with a
soft brush.
● Remove all accessories from the oven.
● Set the oven to conventional function.
14
Advertisement
Table of Contents
