Installing a diffuser
Optional diffuser lenses are available to modify the beam width; see table below for details. The label
identifying the nominal diffuser beam angle is partially hidden under the silicone gasket. The diffuser is
held in place either by the included trim ring or, if installed, by the snoot.
Diffuser kit
None
Narrow
Medium
Wide
Very Wide
Asymmetric
To install an optional diffuser lens:
1.
Shut down power to the fixture.
2.
Position the diffuser lens over the front with the labelled, smooth side facing out.
3.
Press the diffuser lens gasket firmly into the recess in the front ring.
4.
Either place a trim ring over the diffuser and fasten with provided hardware, or install a snoot as
described below.
Nominal
Part number
half-peak beam
angle
-
-
91610145
10°
91610146
20°
91610147
40°
91610148
60°
91610149
10° x 60°
™
Exterior Wash
Diffuser installation
TM
Exterior Wash
100 Series User Manual
Half-peak
beam angle,
110 model
10°
14°
22°
41°
61°
14° x 61°
100 Series Diffuser Kits
Half-peak beam
angle, 100 &
120 models
7°
12°
21°
40°
60°
12° x 60°
13