K: Fuselage Skins; L: Hopper; M: Wings - THRUSH S2R – G10 Maintenance Manual

AIRCRAFT MAINTENANCE MANUAL
J: TAIL GEAR (Continued)
Check the taper bearings spindle and spline-shaft
for corrosion and wear.
8.
MIL-G-81322
reassembling wheel.
Check the centering springs for corrosion,
9.
attachment security and correct operation.

K: FUSELAGE SKINS

Inspect all panels and cowlings for cracks,
1.
chaffing, paint and security of fasteners.
Check the Camloc receptacles for corrosion, wear,
2.
and locking action.
Inspect cockpit enclosure skins for cracks, paint
3.
and security.
Inspect the hopper baffles for security and
1.
condition.
Check the hopper lid for condition of seal and
2.
security of latches.
Inspect the hopper for evidence of leaks and for
3.
general condition.
Check the gate for evidence of leaks and for
4.
proper operation.
Check the hopper vent tube for corrosion and
5.
security.
Check the gaskets on both the return and outlet
6.
lines.
Check emergency shut-off valve for leaks and
7.
proper operation
Check the hopper gate handle and the push rod
8. for cracks around the welds. Check the condition
of the push rod boot.
Inspect the aileron brackets for cracks and
1.
security.
Effective: 03/26/2010
THRUSH AIRCRAFT, INC – MODEL S2R-G10
Grease bearings with
(Aeroshell 22)

L: HOPPER

M: WINGS

grease before
X
X
X
X
X
X
X
X
X
X
X
X X
X
X
2-21
Page