Spray Dispersal System; Dispersal System Maintenance - THRUSH S2R – G10 Maintenance Manual

AIRCRAFT MAINTENANCE MANUAL
* NOTE *
Excessive uncured adhesive can
be cleaned up with ketone type
solvents. (When using solvents,
extinguish all ignition sources
and follow the manufacturer's
directions and precautions for
use and handling
materials.)
adhesive to substrates should be
made within
minutes after mixing.
life is eighty minutes.
temperatures will reduce these
times.

DISPERSAL SYSTEM MAINTENANCE

In conjunction with the manufacturer's
instructions for maintenance of the spray
pump, it is recommended that at the 100
hour inspections
Effective: 03/26/2010
THRUSH AIRCRAFT, INC – MODEL S2R-G10
such
Application of
seventy-five
Working
Higher
Figure 9-3: Liquid Dispersal Equipment
the following be
Allow 24 hours for sealer to cure before
putting airplane back into service. Reinstall
tubes, controls and cables and pump. Fill
hopper and check for leaks. Water should
be allowed to stay in hopper for a minimum
of two hours with no leaks.

SPRAY DISPERSAL SYSTEM

Ref. Figure 9-4
The standard spray dispersal system of the
S2R-G10 consists of the hopper, the
pressure loading valve and tube, the
gatebox, the spray pump, recirculation valve,
delivery plumbing, and the nozzle equipped
spray boom.
accomplished:
A. Inspect the hopper baffles for security
and condition.
B. Inspect hopper lid for condition of seal
and security of latches.
9-5
Page