Flap Removal; Flap Installation; Flap Rigging - THRUSH S2R – G10 Maintenance Manual

AIRCRAFT MAINTENANCE MANUAL

FLAP REMOVAL

A. Disconnect flap push rod at flap. Do
not change position of rod end on
push rod. (See Figure 7-5)
B. Remove flap hinge bolts.
C. Remove flap from aircraft.

FLAP RIGGING

A. With the master switch "ON," fully
retract the flaps (up flaps) with the
flap switch.
Effective: 03/26/2010
THRUSH AIRCRAFT, INC – MODEL S2R-G10
Figure 7-5: Flap Operating Mechanism

FLAP INSTALLATION

Installation of the flap is the reverse of the
removal procedure. In the event push rod
length has been altered, the flap will have to
be completely re-rigged.
B. Disconnect the flap push – pull rods at
the torque tube arms.
C. Hold a straight edge on the wing lower
surface at
(approximately 24 inches outboard of
the fuselage side).
wing station 49.0
In the properly
7-9
Page