THRUSH S2R – G10 Maintenance Manual page 142

AIRCRAFT MAINTENANCE MANUAL
normal installation
described previously. Torque all nuts
to specification per Table 7-3.
Figure 7-14: Attach Angle Mounting to Fuselage Frame
C. Install the wing attach bolts at the left
and right rear spars and torque to
specification.
D. On the 20243-3 wing attach angles
(outboard only), draw a heavy black
line from top to bottom so as to
bisect the forward face of the flange
when it is positioned on the aircraft.
E. Position these outboard angles so
that they mate
Effective: 03/26/2010
THRUSH AIRCRAFT, INC – MODEL S2R-G10
procedure
flush with the
bushings through the vertical fuselage
tube, flush with the spar web and
contact the top of the lower spar cap.
Now raise the angle so that there is
approximately a 3/16 inch clearance
between the angle and the spar cap.
Clamp the angle to the vertical fuselage
member.
F. Sight through the outboard vertical row
of ¼" bolt holes in the main spar web
7-25
Page