THRUSH S2R – G10 Maintenance Manual page 181

AIRCRAFT MAINTENANCE MANUAL
B. Apply a light cost of Dow Corning
Molycoat M-77
generator spline mating surface.
C. Position the starter-generator on the
mounting adapter and secure it in
place with the
clamp.
D. Close the clamp hinge over the T-
bolt. Check with a mirror to make
certain the clamp
captures both the flange on the
quick-disconnect adapter and the
flange on the
around its entire circumference.
10-6
Page
THRUSH AIRCRAFT, INC - MODEL S2R-G10
to the starter
quick-disconnect
groove fully
starter-generator
E. When the clamp is properly positioned
and the hinge and T-bolt are closed,
tighten the T-bolt nut to a torque of 70
inch pounds.
clamp lightly with plastic/rudder mallet.
Re-torque T-bolt nut to 70 inch pounds
and repeat until you achieve 70 inch
pound of torque without nut moving.
F Connect the electrical leads to the
starter-generator as previously marked.
G Secure the upper aft engine cowling and
connect the batteries. Run the engine
at idle speed for at least two minutes.
Shut down the engine and recheck the
quick-disconnect
torque.
Tap circumference of
clamp for proper
Effective: 03/26/2010