Terminal Strips Of The Power Circuit - KEB Combivert F5 series Instruction Manual

Connection Terminals
2.5

Terminal strips of the power circuit

Attention! 230 V and 400 V-classes are possible
All terminal strips meet the requirements on EN 60947-7-1 (IEC 60947-7-1)
Housing size A
Motor side
Housing size B, D, 12...14.E.400 V
++
L1 N/L2 L3
Housing size E.200 V and ≥ 15.E.400 V
++
L1 L2 L3
GB - 22
Line side
--
PB U V W
T1
--
PB U V W
T1
Name Function
U, V, W
Motor connection
PA, PB Connection for braking resistor
T1, T2 Connection for temperature sensor
++, – – Connection for braking module,
Regenerative unit and supply unit or as DC
voltage input 250...370 VDC (230 V class)
420...720 VDC (400 V class)
L1, N 1-phase mains connection
L1, L2, L3 3-phase mains connection
PE Connection for shielding /earthing
Name Function
L1, N 1-phase mains connection
L1, L2, L3 3-phase mains connection
U, V, W Motor connection
++, PB Connection for braking resistor
T2
++, – – Connection for braking module,
regenerating front
end and supply units or DC
voltage input
250...370 VDC (230 V class)
420...720 VDC (400 V class)
T1, T2 Connection for temperature sensor
Connection for shielding /earthing
PE,
Name Function
L1, L2, L3 3-phase mains connection
U, V, W Motor connection
++, PB Connection for braking resistor
++, – – Connection for braking module,
T2
regenerating front
end and supply units or DC
voltage input
250...370 VDC (230 V class)
420...720 VDC (400 V class)
T1, T2 Connection for temperature sensor
Connection for shielding /earthing
PE,
Cable cross-section terminal no.
Cable cross-section terminal no.
Cable cross-section terminal no.
1
2
3
4
5
3
4