Table of Contents
Advertisement
3-14, EJECT LEVER, SWITCH LEVER ASSEMBLY,
3)
PINCH ROLLER SUB ARM ASSEMBLY
Removal (See Fig. 3-15.)
Remove the DC motor (capstan motor) as described in
section 3-3,
Set the [STOP] mode.
Remove the claw @, then remove the eject lever @.
Remove the stopper washer @ , then remove the switch lever
assembly @.
Remove the pinch roller load spring @.
Remove the stopper washer @, then remove the pinch roller
sub arm assembly @.
Installation (See Fig. 3-15.)
Grease the axle @ (See Fig. A).
Assemble by inserting ® part of the pinch roller sub arm
assembly @ into the slot @, then insert the pin @ into the
loading lever assembly notch @ .
Secure with the stopper washer @.
@ Stopper Washer
© Pinch a
@ Pinch Roller Sub Arm
Assembly
Half a drop of oil
oe
®
°
4)
5)
6)
72
8)
9)
Mount the pinch roller load spring @ by catching its @ end
between the claw @® and the chassis side and its @ end to the
claw @.
Apply half a drop of oil to the axle ® (See Fig. B).
Align the groove @ of the switch lever assembly @ with the
mode detector switch protrusion ® , mount it on the axle®,
then insert the pin @ into the drive gear (left) assembly @
'outer groove.
Secure with the stopper washer @ .
Mount the eject lever @ and close the claw @.
Mount the DC motor (capstan motor) as described in section
3-3.
Note: When mounting the switch lever assembly @ onto' the
—19—
/
axle ® with the tension regulator arm assembly installed,
set the pin @ to the arrow @ side of the switch lever
assembly @.
© Stopper Washer
© Switch Lever Assembly
© Pin
Advertisement
Table of Contents
