Connecting Cables - Hamamatsu Photonics C8484-16C Instruction Manual

C8484-16C Instruction manual Ver.1.5

7. CONNECTING CABLES

Refer to the figure below when connecting the various cables.
Camera
Camera head
① Camera head extension cable
Camera control unit
• When cables are connected, confirming the power switch of the computer is the OFF
position.
① Camera head extension cable
Cable used for connecting the camera head to the camera control unit.
② CameraLink interface cable (Option)
Cable used for connecting the CameraLink interface connector to the CameraLink interface
board mounted on the host computer.
③ Camera cable (Option)
Cable used for connecting the camera head to the AC adaptor.
•
Note
10
Rear panel
② CameraLink interface cable
(Option)
Hamamatsu recommends optional interface for the camera.
- AC adaptor: Recommendation article of Hamamatsu
- Camera cable: A3194-01
- CameraLink interface cable: A9262-05
Depending on type of interface cables, the camera may not keep CE marking
compliance in terms of EMC directive.
(Recommendation article
CAMERA
③ Camera cable
(Option)
Figure 7-1
AC adaptor
of Hamamatsu)
ＬＩＮＥ
PC
CameraLink interface board