Command Initial Setting - Hamamatsu Photonics C8484-16C Instruction Manual

C8484-16C Instruction manual Ver.1.5

10-5 COMMAND INITIAL SETTING

Settings commands are set as shown below with the power is turned on.
These settings are initialized, regardless of the "INI" command.
Category
Mode setting
commands
Parameter setting
commands
Correctional
commands
Other setting
commands
34
Initial command Detail
AMD N Exposure start timing
Exposure time setting
NMD N
(in the free running mode)
Exposure time setting
EMD E
(in the external control mode)
SMD N Scan mode
ADS 12 Digital data output bit count
Electronic shutter speed
SHT 160
(in the free running mode)
Frame blanking count
FBL 9
(in the free running mode)
Electronic shutter speed
EST 160 (in the internal setting at the time of
External control mode)
SHA K
Digital output horizontal pixel count
ATP N
External trigger pulse polarity
SPX 2 Super pixel readout
Horizontal offset
SHO 160
(in the sub-array readout)
Horizontal line width
SHW 1024
(in the sub-array readout)
Vertical offset
SVO 0
(in the sub-array readout)
Vertical line width
SVW 1024
(in the sub-array readout)
Input connector
ESC I
(for external trigger)
CEG L Contrast enhancement gain
RES Y Responses are made to commands.
Free running mode
Normal
Edge
Norma readout
12 bit
160
9
160
1024
Negative
2×2 binning
160
1024
0
1024
Digital interface
connector
Low