Hamamatsu Photonics C8484-16C Instruction Manual page 39

SHO
(Scan H-Offset)
Parameter n (0n1336, n = multiples of 8)
Function
Example
SHW (Scan H-Width)
Parameter m (8≦m≦1344, m=multiples of 8)
Function
Example
SVO
(Scan V-Offset)
Parameter n (0≦n≦1016, n=multiples of 8)
Function
Example
SVW (Scan V-Width)
Parameter m (8≦m≦1024, m=multiples of 8)
Function
Example
ESC
(External trigger Source Connector)
Parameter I (Digital Interface connector) / M (Digital 6-pin Multi connector)
Function
Example
(3) Correctional commands
CEG (Contrast Enhance Gain)
Parameter L (Low) / H (High)
Function
Example
Selects the sub-array's horizontal start address.
When the n value is set to a number that is not a multiple of 8, the
command returns an error (E3) in response. Furthermore, the SHA setting
is enabled when the SHO command is processed.
Selects the sub-array's horizontal line width.
When the n value is set to a number that is not a multiple of 8, the
command elicits an error (E3) in response. Furthermore, the SHA setting is
enabled when the SHW command is processed.
Sets the vertical start address for the sub-array readout.
When the n value is set to a number that is not a multiple of 8, the
command elicits an error (E3) in response.
Selects the vertical line width for readout in sub-array or binning mode.
Offset 256 (start address 256)
Width 512
SVO 256
SVW 512
SHA F
SMD A
Selects input connector for external trigger.
Receives external trigger from Digital interface connector of
ESC I
the camera control unit.
Receives external trigger from Digital 6-pin multi connector of
ESC M
the camera control unit.
Sets the gain for the Contrast Enhance function.
CEG L Gain is set to Low (0 dB).
Gain is set to High (14 dB).
CEG H
C8484-16C Instruction manual Ver.1.5
256
512
37