Name And Function Of The Parts; Camera Head - Hamamatsu Photonics C8484-16C Instruction Manual

C8484-16C Instruction manual Ver.1.5

6. NAME AND FUNCTION OF THE PARTS

6-1

CAMERA HEAD

[Front]
① Lens mount
C-mount lens or optical system with C-mount can be attached.
Note
② Camera head extension connector
Connector used for connecting the camera head to the camera control unit.
③ Camera mount
Jig for fixing the camera head. Used when mounting the head on a tripod or other fixture.
8
①
• C-mount has a depth of 7 mm. Screwing the lens too far into the
camera head may scratch the glass surface.
• When fitting the camera head to a tripod or other fixture, use the
screw (1/4-20UNC) in the center of a camera mount or the threaded
sleeve (M3) about the mount's perimeter. Be careful not to allow the
fitting screw to enter more than 5 mm from the surface of the mount.
Screwing this in excessively may impair normal operation.
[Side]
②
③
Figure 6-1
[Rear]