Table of Contents
Advertisement
C9300-201 Ver.1.2
7. CONNECTING CABLES
Refer to the figure below when connecting the various cables.
Camera
SERIAL I/F
DIGITAL OUT
TIMING I/O
POWER
CameraLink interface cable
○
2
•
When cables are connected, confirming the power switch is in the OFF position.
① Camera cable (Option)
This connects the camera to the AC adapter.
② CameraLink interface cable (Option)
This connects the CameraLink interface connector to the CameraLink interface board
mounted on the host computer.
③ Power supply cord (Option: The accessories of A3472-06)
•
Hamamatsu recommends optional interface for the camera.
Note
Depending on type of interface cables, the camera may not keep
CE marking compliance in terms of EMC directive.
10H
Camera cable (option)
○
1
- AC adaptor: A3472-06
- Camera cable: A3194-01
- CameraLink interface cable: A9262-05
AMAMATSU PHOTONICS K.K.
AC adaptor
(A3472-06: option)
ＬＩＮＥ
COOLING
NORMAL
Computer
Fig. 7-1
Power supply cord
○
3
CameraLink
interface board
Advertisement
Table of Contents
