Operation; Preparation For Imaging; Imaging; End Of Imaging - Hamamatsu Photonics C8484-16C Instruction Manual

8. OPERATION

8-1

PREPARATION FOR IMAGING

(1) Connect the equipment as shown in Figure 7-1 before operating of the camera.
(2) After turning the power switch on, wait approximately 10 minutes for the
temperature to stabilize; this completes preparation for imaging.
8-2

IMAGING

The camera works with following setting after power is switched ON.
The camera mode and parameters can be changed by command from the host computer,
which transmitted via the CameraLink interface.
8-3

END OF IMAGING

Carry out the procedure below when imaging is finished.
(1) End imaging or transmission of image data.
(2) Turn off the power to the camera and peripheral equipment.
• When cables are connected, confirming the power switch of the computer is
the OFF position.
Digital data output pixel count
Operation mode
Exposure time setting
Contrast enhancement gain
Digital data output bit count
C8484-16C Instruction manual Ver.1.5
1024
Normal readout
Normal setting
0
12 bit
11